Measure belt
- Print this page and cut the measure belt(s), measure with ruler if every unit appropriate 1 mm for example from the stroke to 60 must be 60 mm(if not, you have incorrectly set the print scale which has to be “none”, that the page is not stretch or shrink to printable area of the page)
- In the increased place of the belt marked with arrow cut it easily below the drawn mark.
- the strip around your finger (numbers up) and plug it into the cut.
- The strip has not to be on the finger nor tightly, even too loose. Do not forget that the ring has to be bigger than the joint of the finger to fit.
- You can read your size on the strip at the cut.
Measure rings
Another way of setting the size (for example if you want to choose a ring as surprise) is comparison the ring (or the traced contour) with the below placed rings. So that after applying the ring on the circle was seen all the edge of the printed ring, but not any white place between the contour to the printed circle and ring.
Table of averages
(values of averages quoted in millimeters)
You can determine the ring size by the ring’s diameter or by the copied outline from the table below:
size | average | size | average | size | average | size | average | size | average |
---|---|---|---|---|---|---|---|---|---|
45 | 14,3 |
51 |
16,2 |
57 |
18,1 |
63 |
20,1 |
69 |
22,0 |
46 |
14,6 |
52 |
16,6 |
58 |
18,5 |
64 |
20,4 |
70 |
22,3 |
47 |
15,0 |
53 |
16,9 |
59 |
18,8 |
65 |
20,7 |
71 |
22,6 |
48 |
15,3 |
54 |
17,2 |
60 |
19,1 |
66 |
21,0 |
72 |
22,9 |
49 |
15,6 |
55 |
17,5 |
61 |
19,4 |
67 |
21,3 |
73 |
23,2 |
50 |
15,9 |
56 |
17,8 |
62 |
19,7 |
68 |
21,6 |
74 |
23,6 |
Warning: All methods mentioned here are indicative only; We are not liable for incorrect use of these instructions. There may be a difference when you print the document or when applying the scales. Accurate measurement can be done in stone jewellery.